40
4. Press the [
→
] key once to blink "0" in the single digit, and
then press the keys [
↑
] or [
↓
] to change it to "8."
・
As a result, "d-18" is displayed.
5. Press the [SET] key.
・
The selection of "d-18" is confirmed, and for example its
Initialize.Val "0.100" is displayed as a current setting value.
・
The display of the setting value automatically returns to that
of the setting item in ten seconds.
6. Press the [MONI/FNC] key.
・
The [FNC] LED turns off, and the console returns to the monitor (MONI) mode.
・
The monitor item, which was displayed before setting the parameter, is displayed for about one second. Then,
its data is displayed.
Operating digit of parameter setting items
●
When setting items of the area A through area S are displayed, an alphabet character or a number blinks, which indicates
the operating digit.
●
Each time the [
→
] key is pressed, the operating digit moves in the following order: alphabet character -> number in
the tens digit -> number in the ones digit -> alphabet character.
●
When a number in the ones digit is changed, in some cases, a number in the tens digit is also changed. For example:
・
A value changes in the following manner: "d-09" -> "d-10," "d-19" -> "d-20" or "d-99" -> "d-
00" by pressing the [↑]
key.
・
A value changes in the following manner: "d-10" -> "d-09," "d-20" -> "d-19" or "d-00" -> "d-
99" by pressing the [↓]
key.
■
How to change parameter setting values
To manually set and change parameters of the converter, perform the following steps on the console:
For example, this section provides procedures for changing the parameter d-18 of the area d from its
Initialize.Val "0.100" to "0.080."
1. When the [FNC] LED on the console is off, press the [MONI/FNC] key.
・
The [FNC] LED turns on, and the console enters the function setting (FNC) mode.
・
A setting item appears in the seven-segment display on the console. For example, immediately after the converter
is turned on, the first item of the basic setting area is displayed.
2. Press the keys [
↑
] or [
↓
] to display the first setting item "d-00" of the area d.
・
The alphabet character "d" in the setting item blinks, which
indicates the operating digit.