TOX PRESSOTECHNIK EQe-K, Original Operating Instructions

Page: 61 / 70

Disassembly and Disposal
TOX_Manual_ElectricPowerDrive_EQe-K_en
61
13 Disassembly and Disposal
13.1 Decommissioning
Decommissioning means that the plant is not in operation for a longer pe-
riod of time but remains at the installation site for recommissioning later.
1. Move plant into home position.
2. Install a restraint device if necessary.
3. Switch off plant at the main switch.
4. Clean the system and protect it against corrosion.
5. Protect plant against loss of data and deep discharge.
13.2 Shutdown
Shutdown means that the system is shut down permanently and/or is pre-
pared for removal.
1. Stop system and wait for it to come to a standstill.
2. Remove material if necessary.
3. Switch off the system at the main switch and secure it against being
switched on again.
4. First disassemble or dismantle after switching off the power (electricity,
pneumatics) and after residual energy has safely dissipated (at least 3
minutes).
5. Remove electrical supply line (first at the terminal, then on the ma-
chine).
6. Remove compressed air supply line.
7. Remove network connection.
8. Clean the system and protect it against corrosion.
9. Protect open cable ends against penetration of dirt.
10. Do not remove cable identifications.