Townlabs TL518, Instruction Manual

Page: 13 / 24

13
Important:
LEDs can be seen through the controller cover are lit under normal operation.
If one of the axes reaches the end of motion or cannot move for any reason, all axes
will stop moving to prevent damage to the machine and motors.
The LEDs will blink indicating the need for a reset.
In order to reset the controller you have to shut it off and then turn it on again .
All previous axes position will be lost.
LED blinking CODES:
•
1 BLINK: Stuck motor. The encoder error exceeded maximum allowed
error
•
2 BLINKS: Motor Halt Command from other motor. The other motor
signaled en error causing the controller to halt all the motors.
•
3 BLINKS: Over-current.
•
4 BLINKS: Thermal overload.
If the controller stops during machining, low the feed, axis acceleration or depth
of cut.