21
Mach 3 software setup
The Mach3 software is highly recommended to use with the mill.
It can be obtained from
http://www.machsupport.com/
.
This is Windows based software.
The mill setup, or configuration file for this software, TL518.xml, is provided on the supplied CD.
After you install the Mach 3, copy this file into Mach3 directory on your hard disk.
Reboot the computer. Click on the “Mach3 loader” icon (not the“Mach3 lathe” or the” Mach 3 Mill”). Highlight the
TL518 profile and click OK.
When you get a Mach 3 screen the software will be set for the mill.
The following Mach3 screen shows the TL518 configuration.
Please note that the velocity value may be changed.
X, Y, and Z Motor Tuning
Summary of Contents for TL518
