NOTE: Pilot and manifold plumbing and
wires are grouped and tied at the
factory to ensure proper connection.
Nylon zip ties must be removed after
connections have been made, and
prior to ignition.
Fig. #2
FRONT CONNECTIONS
1. Remove one screw from the center rear of the fi rebox and use
it to attach the manifold assembly. (Fig. #1)
2. Remove the 2 screws from the fi rebox bottom. (Fig. #1b)
3. Attach the manifold supply tube from the lower manifold to the
front bulk head fi tting and tighten. (Fig. # 2)
4. Attach the pilot supply tube from the forward pilot to the front bulk
head fi tting and tighten. (Fig. # 3)
Fig. #3
NOTE:
If unit is to be converted to Propane, see Propane conversion instructions on
page 8 before proceeding.
The panel set instructions must be used when installing this burner. Typically all
panels except the right side should be installed prior to burner installation.
NOTE: Plug the 4 vacant holes in the bottom of the fi rebox with #8x1/2” screws.
The holes are not required for this style of burner.
Fig #1b
SCREWS
TC54.NGO3C2 070211-16
Fig #1
INSTALL MANIFOLD ASSEMBLY
3
Black Diamond Burner Installation
Summary of Contents for TC54.NG03C2
Page 13: ...TC54 NGO3C2 070211 16 Notes 13 ...
Page 14: ...TC54 NGO3C2 070211 16 Notes 14 ...
