8
❏
5. Take out the T-pins. Glue the tri-stock
fi
n braces into
position with 30-minute epoxy, using T-pins to hold them in place.
❏
6. While you have some epoxy mixed, glue in both wing
dowels.
❏
7. Fit both hardwood servo rails in the slots in both sides of
the fuselage. Position the forward rail as far forward as it will
go and glue it into place, but do not glue in the aft rail until
instructed to do so.
Hook Up the Controls
❏
1. Connect the clevis to the third hole out from the bottom
of the elevator horn.
Note:
If the silicone retainer on the elevator clevis rubs against
the inside of the fuselage sides, use a hobby knife to trim the
inside of the fuselage as necessary for free, smooth movement.
❏
2. Connect the rudder pushrod to the control horn the
same way.
