❍
13. Place the belly pan in position on the wing, aligning it
with the fuselage. Trace the outline of the belly pan onto the
wing with a felt-tip marker.
❍
14. Remove the covering from the edge of the inside of the
belly pan. This is most easily done by carefully sanding the
edge with a sanding block. Be careful to only sand it as much
as needed to remove the covering.
❍
15. Glue the belly pan in place on the wing, making sure
it is aligned with the fuselage. Once the glue has cured,
remove the wing from the fuselage.
INSTALL THE MAIN LANDING GEAR
❍
1. Cut the covering away from the landing gear blocks on
both wing panels.
❍
2. Insert the
landing gear wires
into the holes in the
landing gear blocks. (The short end of the wire is the end that
is inserted into the landing gear block). Do this for both wings.
❍
3. Locate two nylon landing gear straps and four 2 x 10mm
sheet metal screws. Locate the nylon landing gear straps over
the landing gear wire. Mark the location for the holes, then
drill a 1/16" [1.6mm] hole into the landing gear blocks. Install
8
