Hawk II User Guide Rev3 23-03-12 Copyright © 2012 TouchStar Technologies Ltd
pg. 32
2.
Start a terminal emulator on the PC, such as Teraterm with the
following settings: baud rate 38400, No parity, 8 data bits, 1 stop bit.
3.
Whilst holding down the debug push-button hard reset the Hawk II
by holding down the reset push-button for 10 seconds.
4.
When the initial boot loader screen appears (see Figure 3 below)
on the terminal emulator, release the debug button, and press the
space-bar in the terminal emulator to prevent the default option of
Program being selected. If the space-bar is not pressed in time,
then the boot loader will automatically carry out the default
selected option. If this should occur, then press escape to return to
the main screen, or repeat step 3.
Figure 3
: Boot loader main screen
