Hawk II User Guide Rev3 23-03-12 Copyright © 2012 TouchStar Technologies Ltd
pg. 23
B) USB Host
– Allows connection to USB based devices such as memory
sticks
C) Ethernet
- Ethernet socket to connect to a standard CAT5e network
D) Audio IN
– Allows connection to an external microphone
E) Audio OUT
– Allows connection to an external speaker
NOTE:
The Hawk II Hub does not require an external power supply.
It is a pass through connection box that handles signals only.
Attaching Cables to a Hawk II Hub
1)
To attach a 9 PIN D-Sub cable to the Hub insert the connector into the
socket on the Hub; using finger and thumb tighten the 2 locking screws to
hold the connector in place. Failure to do so may result in loss of
connection. Before you connect the cable make sure both connectors
are correctly oriented and aligned.
2)
To attach a USB cable to the hub simply insert the connector into the
socket. The USB connectors have a friction fit. Before you connect the
cable make sure both connectors are correctly oriented and aligned.
3)
To attach an Ethernet cable into the hub insert the connector into the
socket until it ‗clicks‘. A snap fit plastic clip will keep the connector in
place. Before you connect the cable make sure both connectors are
correctly oriented and aligned.
4)
To attach either an Audio IN or Audio OUT cables simply insert the
connector into the socket. The Audio connectors have a friction fit. Before
you connect the cable make sure both connectors are correctly oriented
and aligned.
Removing Cables from a Hawk II Hub
