9
(1)
(2)
Caution
let.
Securing the Dispenser
Two flashes every second means.
Liquid soap level is near empty.
Eight flashes every second means.
The sink is reflecting off the sensor light, cau-
sing an obstruction.
Lamp inside sensor (red)
Hex nut
Make sure not to cover the sensor light with your hand or place any
objects inside the sink bowl, as this will cause the Lamp inside the
sensor located at the front of the dispenser to flash off and on.
If the light continues to flash even after removing
any obstacles, adjust the position of the dispens-
er until the light stops flashing.
The sensor light flashes in two different modes.
Secure the dispenser with the hex nuts provided. The hex nuts are
positioned 1/2Ó (13mm) apart on opposite sides of the dispenser.
Certain types of ceramic may cause the sensor light
to flash off and on continuously. In this case, follow
the standard installation procedure. The sensor will
automatically recalibrate itself.
Once the unit has been turned on, the light will stop
flashing after 10 minutes.
If the dispenser position is still being adjusted when the flashing light automatically
goes out after 10 minutes, pull the power cord out of the wall outlet and reinsert.
Be sure to wait at least 10 seconds before inserting the plug back into the wall out-
If installation is not completed before sensor is calibrated.
