6
WARNING
Refrain from sitting on the seat for long periods.
•
It may cause low-temperature burns.
To prevent the following persons from getting a moderate temperature burn during use, other
person should turn off the toilet seat heater and set the dryer temperature to "Low".
−
Young children, the aged and other users unable to set the temperature appropriately
themselves.
−
The ill, physically disabled and others who do not have freedom of movement.
−
Those using any medicines that cause drowsiness (sleeping or cold medicine), those who
have been drinking heavily, anyone severely fatigued and anyone else liable to fall asleep.
This is an electrical product. Do not install it anywhere water is likely to get on
the product or anywhere with humidity high enough that water is likely to form
on the surface of this product. When using the product in a bathroom, install a
fan or ventilation port and ensure good air
fl
ow through the bathroom.
•
Failure to do so may cause
fi
re or electrical shock.
Always connect the product to the cold water supply.
•
Connecting to hot water supply may result in burns and equipment damage.
Check that an appropriate ground is installed.
•
If the ground is not installed, if there is a breakdown or electrical current leak, the lack of a
ground could cause electrical shock.
For the ground, use copper wire with a ground resistance of 100
Ω
max. and a diameter of 1.6 mm min.
•
If there is no ground installed, ask the contractor who did the installation to install the ground.
Make sure that a properly grounded (3 prong) outlet has been installed.
•
Failure to install a grounded outlet could cause electrical shock in the event of a malfunction or
short circuit.
Insert the power plug securely into the outlet.
•
Failure to do so may cause
fi
re, heat or short circuit.
Check that the power plug is waterproofed with silicone rubber.
•
A power plug that is not water-proofed may cause
fi
re and electrical shock.
•
If the power plug is not water-proofed, ask the contractor who did the installation to water-proof it.
To unplug, hold the power plug, not the power cord.
Do not unplug by pulling the power cord.
•
Pulling on the power cord may cause damage and result in
fi
re or heat.
If the electric cord is damaged, avoid danger by having the manufacturer’s
repair department or equivalent specialist replace it.
Always switch the breaker on the distribution board to OFF before cleaning
or maintenance.
•
Failure to do so may cause electrical shock or malfunction.
Safety Precautions
(Continued)
Summary of Contents for NEOREST DH TCF9575 Series
Page 52: ...51 3 Select or ENGLISH LANGUAGE ENGLISH Press LANGUAGE ENGLISH To return Reference...
Page 75: ...74 MEMO...
Page 76: ...75 MEMO...
