5
ENGLISH
INSTALLATION PROCEDURE
CARE & CLEANING
4
5
6
2
3
1
Ill. 9
Seat
Hinge
Cap
Plastic
Bolt
Seat
Stopper
Bowl
Plastic Nut
1 - Cap
2 - Plastic Bolt
3 - Seat Hinge
4 - Seat Stopper
5 - Toilet Bowl
6 - Plastic Nut
MOUNTING HARDWARE
angle stop (ill. 8). Make sure that the hose is
free of kinks.
NOTE:
The water supply pressure should be
20 to 80 psi static.
13) Install the toilet tank lid onto the toilet tank top.
12) Flush toilet a few times to check for issues and leaks.
Make sure NO WATER LEAK on bowl and tank.
14) Install the toilet seat onto the toilet bowl
using the mounting hardware in the toilet
seat box (ill.9). Place seat onto bowl and
rotate the hinge down. Position seat
stoppers under the seat hinge. Insert bolt
into seat hinge and through the toilet
bowl. Install plastic nut onto bolt from
underneath. Tighten the bolt securely.
Install the seat bolt caps.
NOTE
: Tighten the seat bolt until the hinge is
secure. The seat and lid will have slight side to
side movement, which is normal. This freedom
of movement allows the seat to SoftClose®
without binding.
Use a detergent or non-abrasive toilet cleaner
and a soft bristled plastic brush to clean your
toilet. To remove hard water stains, use vinegar
or lime dissolving cleaner and a non-scratch
scour pad made for porcelain. Allow a little
contact time to allow the cleaner to dissolve
the buildup.
NOTICE
DO NOT USE IN-TANK BOWL CLEANERS.
The use of high concentration of chlorine or
chlorine-related products can seriously damage
leakage and property damage. TOTO shall not
failure or damage caused by the use of in-tank
bowl cleaners.
50 mm radius minimum Make sure there are no kinks
ill. 9
ill.8
