Toto 20899, Manual

Page: 22 / 96

Cleaning the Blade-Stop
System Shield
Service Interval: Every 25 hours
1. Disconnect the spark-plug wire from the spark
plug; refer to
Preparing for Maintenance (page
17) .
2. Tip the machine onto its side with the dipstick
down.
3. Remove the 2 blade nuts and the stiffener
(
Figure 50 ).
g003133
Figure 50
1. Blade nuts 4. Blade driver
2. Stiffener 5. Anti-scalp disk
3. Blade 6. Blade-stop system shield
4. Remove the blade ( Figure 50 ).
5. Remove the blade driver and the anti-scalp disk
(
Figure 50 ).
6. Remove the blade-stop system shield ( Figure
50 ).
7. Brush or blow out debris from the inside of the
shield and around all the parts.
8. Install the blade-stop system shield that you
previously removed.
9. Install the blade driver and anti-scalp disk that
you previously removed.
10. Install the blade and the stiffener with the 2 blade
nuts that you previously removed (
Figure 50 ).
11. Install the blade nuts.
Note:
Torque the blade nuts to 20 to 37 N∙m
(15 to 27 ft-lb).
21