www.totalsheds.co.uk
© Sheds (Midlands) Limited 2021
STEP • 13
STEP • 12
Page 10
x2
4.0 x 70mm
Per Front Tops
SIDE PENT ANGLE TOPS
Now attach all the Side Tops
of Pent Shed End Panels.
PENT FRONT TOPS
Place the front tops of shed.
Use 2ft Section for below models.
6x6ft • 6x10ft • 6x14ft • 6x18ft
12a. Place the right and left Pent Angle Tops as shown below.
Make sure the higher ends are at the front of the shed as shown in the diagram below.
12b. Adjust the panels so that the tounge & groove are fixed together in place correctly.
Use a hammer to lightly tap in to the grooves to create a perfect fit.
13a. Place the 4ft Pent Front Top sections in place. Use any 2ft sections if your shed size is
one of the above. Make sure the 2ft section is placed on top of the 2ft front panel only as
shown in the diagram.
13b. Adjust the panels so that the tounge & groove are
fixed together in place correctly. Use a hammer to lightly
tap in to the grooves to create a perfect fit.
13c. Attach the sections down by screwing through
the inner frameworks of both panels.
12c. Attach the sections down by screwing through
the inner frameworks of both panels.
= Drill Points using
screws provided as shown
= Drill Points using
screws provided as shown
x4
4.0 x 70mm
DRILL
DRIVER
DRILL
DRIVER