Firmware Version
Current version of software installed on the Advanced Cable Tester
v2.
Hardware Version
Current version of hardware installed on the Advanced Cable
Tester v2.
Serial Number
Serial number of the Advanced Cable Tester v2. This serial
number should match the label on the rear of the tester.
Module Insertion Count
The cable test modules use an edge connector system to interface
with replaceable connector interfaces. The edge connector system
is rated for 1,000 insertions and the user can see the current wear
level on the unit. Once the module insertion limit has been
reached, the Advanced Cable Tester v2 will need to be serviced by
Total Phase.
Total Cable Test Count
The total number of cable tests that have been performed by this
unit over its lifetime.
Total Local Test Reports
The total number of test reports that are currently in the non-
volatile storage of the Advanced Cable Tester v2. The tester has a
circular bu
ff
er and will maximize the number of tests that can be
stored. Once the test starts to approach the limit, it will
automatically delete the oldest tests. It is also possible to purge all
the test on the tester by using the
Delete All Reports
feature.
Please be careful because once the test reports are deleted, it is
not possible to recover them.
8.7.2 Device Information
This section displays information speci
fi
c to the cable connector module that is currently
installed in the Advanced Cable Tester v2. The ACT v2 detects when a module has been
inserted or removed and will update the information displayed here. If no cable module is
installed, the interface will indicate that "No Module Installed." Additional information
available in this section is described in Table 17.
Table 17
: Module Information
Module Installed
The type of Connector Module that is installed in the Advanced
Cable Tester v2.
Module Serial Number
The serial number of the currently installed Connector Module.
Advanced Cable Tester v2 User Manual v2.0.0
60
