TOTAL GYM
®
XTREME OWNER’S MANUAL |
INSPECTION, MAINTENANCE & STORAGE
13
7A.
With caution, to avoid pinched fingers or hands, grab the
top of the Glideboard and slowly pull the unit up allowing the
rollers to bring the back of the unit towards the center. Keep
approximately 30.4 cm / 12 in / 12 po apart.
7B.
Continue to fold the exerciser together until it is completely
folded and roll the exerciser into a closet for storage. To store
under a bed, simply lower the exerciser to the floor and roll
under the bed.
Lift Here
Front Crossbar
Back Crossbar
CRUSH HAZARD
KEEP HANDS CLEAR
DURING FOLDING.
WARNING
!
WARNING LABEL 4
30.4 cm
12 in
12 po
NOTE:
Do not store unit in upright position when folded.
TO REMOVE THE GLIDEBOARD
You can also remove the Glideboard if you need to fit the exerciser
under a narrow space (between 15.2 cm / 6 in / 6 po and 20.3 cm
/ 8 in / 8 po).
IMPORTANT:
The Glideboard weighs approximately 9.2 kg./20 lbs.
Use caution when lifting it off of the exerciser. Lifting incorrectly
may result in user injury.
1.
With exerciser laying flat on the floor, disconnect the pulley from
the hook on the underside of the glideboard.
2.
Next, tilt up the glideboard and slide it off the frame of the
exerciser. When the bench is completely off the exerciser, set it
aside.
3.
Next, pull the Spring Loaded Pin to release the Rail and fold the
exerciser together as shown in Fig. 7B. Be sure you release the
Spring Loaded Pin before folding.
TO ATTACH THE GLIDEBOARD TO GYM WHEN
SETUP AND READY FOR USE
1.
Remove Adjustable Workout Card Deck Holder from top of
vertical column.
2.
Raise rails to the highest level on the vertical column and insert
Straight Safety Pin.
3.
Carefully pickup the glideboard with both hands, one on each
side, making sure the hook on the underside of the glideboard
is at the top closest to the vertical column.
4.
Line up the glideboard with the lower rails on your gym and
gently lower the glideboard down the rails until it rests against
the rubber stops.
5.
Connect pulley to top underside of the glideboard by taking the
pulley and sliding it onto the hook that is on the underside of
the glideboard.
6.
Insert Adjustable Workout Card Deck Holder on the top of
vertical column.
Fig. 7B
