Total Gym APEX G1, Owner'S Manual, Page: 7 / 16

SHOP
more attachments, accessories & tools at totalgymdirect.com //
TOTAL GYM
®
// 6
SET UP
4. Make sure the handles are out to the sides before you begin to
unfold your unit. Keep hands and fingers away from pulley. Hold
onto the top center of glideboard and begin rolling rear rollers.
Spread the unit out until it is flat on the floor. Be careful to do this
SLOWLY .
BE SURE TO SUPPORT THE FRAME IN THE CENTER TO AVOID
HAVING THE PRODUCT DROP SUDDENLY ONTO THE FLOOR OR
PINCH FINGERS.
HOLD HERE WHILE
LOWERING TO
THE GROUND
5A . Next remove plastic packing ties from the top and bottom of
the vertical column. Pull out the Spring Loaded Pin located at the
left rail ( NOTE: pin shown in picture is on left side of unit standing
behind it and looking at the back of the vertical column) to release
Spring Loaded Pin. Continue to hold pin out while performing the
next step.
HEIGHT ADJUSTMENT
QUICK RELEASE PIN
SPRING
LOADED
PIN
5B . Take hold of the vertical column and pull it up until it is upright.
Release the Spring Loaded Pin. You should hear it lock back into
place. ( NOTE: pin shown in picture is on left side of unit standing
behind it and looking at the back of the vertical column).
SPRING
LOADED
PIN
IMPORTANT: Be sure the Spring Loaded Pin is locked into place
before using your unit. You will know the pin is locked into place
when you can see the end protrude through the inside of the
rail bracket.
6. Position one foot on back crossbar to keep the product from
lifting off the floor. With one hand on either the right or left rail and
the other hand pulling the Height Adjustment Quick Release Pin
out, slide the rails along the vertical column to desired position and
release pin. Pin will lock into place—you will hear a loud click once
locked. Last, insert Safety Hitch Pin (attached with a lanyard to the
height adjustment assembly) into the hole of the height adjustment
assembly and vertical column (directly into the opposite side of the
Height Adjustment Quick Release Pin).
NOTE: Insert Safety Hitch C Pin into side hole located directly below
height adjustment assembly on vertical column.
HEIGHT ADJUSTMENT
QUICK RELEASE PIN
SAFETY HITCH
C PIN
SPRING
LOADED PIN