15
NOTE:
The upper guide rail and the side panels are offset to provide the proper pitch to the rear of
(5/16” or 7.9375 mm). This is necessary for proper condensed water utilization and drainage. Even
if you are not using the side panels, the rear pitch must be maintained!
Step 1:
Place unit on floor, a bench or a table. There is a Left-side and Right-side Filler Panel. Be sure to use
the proper panel for each side. When installed, the flange for securing the panel in place in the
windowsill will be facing into the room.
a.
Hold the side Panel in one hand and gently pull back the center
to free the open end. See Figure 1.
b.
Slide the free end “T” section of the panel directly into
the cabinet as shown in Figure 2. Slide the panel down.
Be sure to leave enough space to slip the top and bottom
of the frame into the rails on the cabinet.
c.
Once the panel has been installed on the
side of the cabinet, make sure it sits se-
curely inside the frame channel by mak-
ing slight adjustments. Slide the top and
bottom ends of the frame into the top
and bottom rails of the cabinet. See Fig-
ure 3.
d.
Slide the panel all the way in and repeat on the other side.
Figure 1
Figure 2
Upper guide rail
Flexible screen
Lower guide
rail
Figure 3
