21
LOCK 210, LOCK 250 AND LOCK 500
A power source with voltage of 12-48V DC +/-20% is
required to operate the Node. The power input port is
equipped with a removable plug-in connector included in
the sales package. Remove the connector if needed and
connect the stripped power wires by tightening the wire
connector screws with a flat blade screwdriver.
A device frame connection is available at the power
input port. It is recommended to wire this connection to the
installation cabinet protective earth potential with as short
cable as possible. This will enhance the immunity of the
equipment against conducted and radiated RF disturbance,
as well as against electrical transients that may be
propagated by the ethernet cables. Use + and - terminals
to power the device. Follow the polarity and grounding
symbols in the front panel.
Make sure the connector is completely plugged in and
secure the connector into the Lock frame by tightening the
locking screws with a flat blade screwdriver. The wires with
a cross-section of up to 1.5mm
2
(AWG 16) can be used with
the connector. The stripping length of the conductor is 6
mm.
The Node is equipped with a 2 Amp internal fuse. In case of
a device malfunction, the fuse is blown to protect the power
circuitry. The fuse cannot be replaced by the user. In case
of a blown internal fuse, do not open the device. Instead,
contact your local Tosibox distributor for service.
LOCK 500*PS
In addition to the powering options for Lock 500, an
AC adapter included in the Lock500*PS-version sales
package may be used. The AC adapter is supplied with
interchangeable plugs that makes it possible to connect
to different electrical outlets. Select and fit the plug that
complies with your local requirements. The AC adapter
DC output connector is coaxial. Therefore, a conversion
cable is necessary to convert from coaxial DC connector to
stripped wires required by the Node power input connector.
The conversion cable is included in the Lock500*PS-
version sales package. Follow the same procedure as with
Lock 500 powering options.
TOSIBOX
®
600 -SERIES
Use the AC adapter included in the sales package.
Alternatively, in case the operating voltage of 9-50V DC
(absolute value) is available from an external power source,
a DC input plug included in the sales package can be used.
