10
Setting up the Remote Control
1
Open the battery compartment on the
front of the Remote Control by pressing on the
centre of the slide cover and pull off in one motion
in the direction of the arrow.
2
Install 2 batteries (“AAA” size) following
the polarity diagrams.
3
Close the battery compartment lid.
4
Point the remote control at the VCR and press the buttons within the operating range.
Distance:
within about 7 m from the front of the remote sensor
Angles:
within about 30˚ in every direction
Notes on batteries
•
The life of the batteries is about 1 year
depending on the conditions of use.
•
If the remote control does not operate correctly,
replace all batteries with new ones.
•
If the remote control is not to be used for a
long period of time, remove the batteries to
avoid possible damage from battery corrosion.
Caring for the remote control
•
Do not expose the remote sensor of the VCR
to a strong light source such as direct sunlight
or illumination (especially high-frequency
lighting) when using the remote control.
•
Be careful not to spill water on the remote
control or to place it on anything wet, and avoid
sharp impacts.
How to Use the Remote Control
This section explains how to get ready for remote control operation.
Whenever you operate the VCR, press
VCR
to set the remote control operating the VCR.
PREPARATION
1
2
