Toshiba Rack Enclosure Installation Manual – 99881-000
10
5)
Rotate the door 180 degrees. Remove the hinges from the door, and re-install them to the same
location on the opposite side. The hinges on door should now align with the hinges on the enclosure.
6)
Install the door to the hinges now on the reverse side of the enclosure frame. See “Installing Door” on
section 7.2 for instructions. Re-connect the ground wire on the opposite side of door and frame.
7)
Reinstall the door handle by removing the cam screw, cam washer, and cam. Rotate the cam washer
90 degrees, and the latch 180 degrees. Install the handle on the door.
8)
Remove and reinstall the Toshiba nameplate.
9.2
Removing Side Panels
1)
Unlock the panel with the key provided.
2)
Tilt the top of the panel away from the enclosure.
3)
Lift the panel away from the brace that supports it.
Figure 9.3 – Side Panel
9.3
Removing/Installing Top Panel
1)
Pull the two spring pins on the rear of the enclosure
near the top panel.
2)
While holding the twos pins, push the top panel upward.
3)
Lift the top panel from the enclosure.
*To re-install the top panel, reverse the steps above.
Figure 9.4 – Top Panel
