Toshiba SureMark 4610 2CR Hardware Manual Download

Page: 56 / 70

Telecommunication regulatory statement

This product is not intended to be connected directly or indirectly by any means whatsoever to

interfaces of public telecommunications networks, nor is it intended to be used in a public

services network.

Electronic emission notices

When you attach a monitor to the equipment, you must use the designated monitor cable and

any interference suppression devices that are supplied with the monitor.

Federal Communications Commission (FCC) statement

This equipment has been tested and found to comply with the limits for a Class A digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference when the equipment is operated in a commercial environment. This

equipment generates, uses, and can radiate radio frequency energy and, if not installed and used

in accordance with the instruction manual, may cause harmful interference to radio

communications. Operation of this equipment in a residential area is likely to cause harmful

interference, in which case the user will be required to correct the interference at his own

expense. There is no guarantee that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:
1. Reorient or relocate the receiving antenna.

2. Increase the separation between the equipment and receiver

3. Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

4. Consult the dealer or experienced radio TV technician for help.
Properly shielded and grounded cables and connectors must be used in order to meet FCC

emission limits. Toshiba Global Commerce Solutions is not responsible for any radio or

television interference caused by using other than recommended cables and connectors or by

unauthorized changes or modifications to this equipment. Unauthorized changes or

modifications could void the user's authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two

conditions:
1. This device may not cause harmful interference, and

2. This device must accept any interference received, including interference that may cause

undesired operation.

FCC Radiation Exposure Statement

To comply with the FCC RF exposure compliance requirements, the separation distance between

the antenna and the body of all persons must be at least 20 cm (8 inches).

Industry Canada Class A Emission Compliance statement

This Class A digital apparatus complies with Canadian ICES-003 and RSS247.
Operation is subject to the following two conditions:
1. This device may not cause interference.

2. This device must accept any interference, including interference that may cause undesired

operation of the device.

4610 Hardware Guide for Models 2CR and 2NR