Software Installation
Strata CIX Database Programming
2-14
Strata CIX PC Attendant Console Installation 06/09
4.
Click on OK.
5.
The screen will change to the Full IP Station Assingment (command 260).
6.
Enter the first four digits of the MIPU (xIPU) card equipment number (cabinet/slot), do not
enter a port number.
7.
In the 01 Type field pull down list, select ATT.
8.
Toshiba recommends entering COS 10 for the following:
•
COS DAY1=10
•
COS DAY2=10
•
COS Night=10
9.
For Call Progress Tones assign Dial Tone. This assigns Dial Tone as the tone heard after LCR
access codes are dialed (required).
10. You must create this as a new port. The ATT parameter cannot be changed later. If the DN
already exists it must be deleted and then added as a new ATT port.
DKT Data Assignments
1.
Select Station > Station Assignments, click on the Prime DN for this particular Attendant
Console in the list on the right side of the screen.
1.
Enter data for the FBs listed below:
p
01 – Station Type select “Attendant” from the pull down list (required).
p
02 – Select the Key Strip Pattern for the Attendant Console (required).
p
05 – Assign Tone First signaling (required).
