66
PROBLEM SOLVING
En
g
li
sh
a
Set the Colour to
Auto
and exit.
b
Go to the
PICTURE
menu and adjust the tint.
Q
What is DVB-T?
A
Digital Video Broadcast via an aerial/antenna.
Q
What is DVB-C?
A
Digital Video Broadcast via a cable connection.
Q
How are radio channels selected?
A
Press
TV
on the remote control and select
DTV
RADIO
. Alternatively select from the GUIDE.
Q
What can be done if the PIN number has been
forgotten?
A
Use the Master PIN code of 1276, then change to a
number of your choice. Ensure that no-one else can
use the Master PIN by removing the Owner’s Manual.
Q
Why are there vertical stripes on the screen when in
PC mode?
A
The
Sampling Clock
may need adjustment. Select
PC
Settings
from the
Display Settings
menu, highlight
Sampling Clock
and adjust until the lines clear.
Q
Why are there horizontal stripes and/or blurred
images on the screen when in PC mode?
A
The
Clock Phase
may need adjustment. Select
PC
Settings
from the
Display Settings
menu, highlight
Clock Phase
and adjust until the picture clears.
Q
Why when
digital
subtitles have been selected are
they not showing on screen?
A
Subtitles are not currently being transmitted by the
broadcaster.
Q
Why are there problems with analogue text?
A
Good performance of text depends on a good strong
broadcast signal. This normally requires a roof or loft
aerial. If the text is unreadable or garbled, check the
aerial. Go to the
main index
page of the text service
and look for the
User Guide
. This will explain the basic
operation of text in some detail. If further information
is needed on how to use text
see the text section
.
Q
Why is a page number visible at the top of the screen
but no text?
A
Text has been selected but Teletext information is
currently unavailable on the current source.
Q
Why are the colours wrong when an NTSC source is
played?
A
Connect the source via a SCART lead and play.
Select
Colour System
from the
SETUP
menu.
Q
Why don't the devices connected via HDMI operate
properly?
A
Make sure to use cables with the HDMI logo
(see page 9).
Some early HDMI equipment may not work properly
with the latest HDMI TV products, due to new standard
adoption. Try switching the HDMI settings (
Enable
Content Type
and
INSTAPORT™
) to
Off
.
Q
Why don't the REGZA-LINK devices work?
A
When the connected REGZA-LINK device does not
work correctly after you have changed the settings of
the device, turn off your television and unplug the
power cord, and then plug and turn on again.
Unplug the HDMI cable of the REGZA-LINK device and
lead again.
Q
Why is the REGZA-LINK logo still showing when
the equipment has been disconnected?
A
If the REGZA-LINK device is disconnected, the logo will
disappear after approximately one minute.
Q
Why don't the networked devices work?
A
The LAN cables are not connected properly or at all.
Connect all cables (see page 12).
Make sure your network address is set up correctly
(see page 35).
Q
Why doesn't the wireless network work?
A
Make sure the TOSHIBA Dual Band WLAN Adaptor
(sold separately) is used (see page 12).
Check that the AP is powered on.
RVXVMV73_WebOM_UK.book Page 66 Monday, April 19, 2010 10:46 AM
