– 29 –
2
Part names
Indoor unit
Outdoor unit (The design varies depending on the outdoor unit.
The following illustration shows an example.)
Air discharge
Connect a discharge duct.
Electrical control box
The earth screw is provided in the
electrical control box.
Drain pan
Air intake
Air filter
Air intake (Side and rear)
Panel
There is an earth screw, valves,
and electric parts inside.
Air discharge
Piping panel
Wiring hole
Refrigerant pipe outlet
Fixing leg
3
Wired remote controller
This remote controller can control the operation of up to 8 indoor units.
Display section
In the display illustration below all the icons are shown. When the unit is in
operation, only relevant icons will be displayed.
•
When the leak breaker is turned on at the first time,
flashes on the
display part of the remote controller.
•
While this icon is flashing, the model is being automatically confirmed.
Wait till
icon has disappeared to use the remote controller.
1
Operation mode
The selected operation mode is displayed.
2
Error display
Displayed while the protective device works or an
error occurs.
3
SETTING display
Displayed during setup of the timer or other
settings.
4
TEST run display
Displayed during a test run.
5
Timer display
The selected timer time is displayed.
When an error occurs, error code is displayed.
6
Timer mode display
The selected timer mode is displayed.
7
Filter display
Reminder to clean the air filter.
8
Fan speed display
The selected fan speed mode is displayed.
9
Set temperature display
The selected set temperature is displayed.
10
Power saving mode display
Limits compressor speed (capacity) to save
energy.
SET
TIME
TIMER SET
TEST
FILTER
RESET
TEMP.
CL
FAN
SAVE
SWING/FIX
VENT
MODE
ON / OFF
UNIT LOUVER
Display
section
Operation
section
1
8
6
16
4
2
3
5
7
13
15
14 17
9
12 1110
(Auto)
(High)
(Med.)
(Low)
57-EN
58-EN
