Installation Manual
–
41
–
41-EN
Wireless remote controller
1
Turn on the power of the air conditioner.
When power is turned on for the
fi
rst time
after installation, it takes approx. 5 minutes
until the remote controller becomes
available. In the case of subsequent
poweron, it takes approx. 1 minute until
the remote controller becomes available.
Execute a test run after the predetermined
time has passed.
2
Push “ON/OFF” button on the remote
controller, select [ Cool] or [
Heat]
with “MODE” button, and then select
[
HIGH] with “FAN” button.
3
Cooling test run
Heating test run
Set the temperature to
17 °C with the temp.
setup buttons.
Set the temperature to
30°C with the temp. setup
buttons.
4
Cooling test run
Heating test run
After con
fi
rming a signal
receiving sound “beep”
immediately set the
temperature to 18°C with
the temp. setup buttons.
After con
fi
rming a signal
receiving sound “beep”
immediately set the
temperature to 29°C with
the temp. setup buttons.
5
Cooling test run
Heating test run
After con
fi
rming a signal
receiving sound “beep”
immediately set the
temperature to 17°C with
the temp. setup buttons.
After con
fi
rming a signal
receiving sound “beep”
immediately set the
temperature to 30°C with
the temp. setup buttons.
6
Repeat procedures
4
→
5
→
4
→
5
.
Indicators “Operation” (green), “Timer”
(green), and “Ready” (orange) in the
wireless receiver section
fl
ash in approx.
10 seconds, and the air conditioner starts
operation. If any of these indicators does
not
fl
ash, repeat procedures 2 to 5.
7
Upon completion of the test run, push
“ON/OFF” button to stop operation.
<Overview of test run operations using the
wireless remote controller>
▼
Cooling test run:
ON/OFF
→
17°C
→
18°C
→
17°C
→
18°C
→
17°C
→
18°C
→
17°C
→
(test run)
→
ON/OFF
▼
Heating test run:
ON/OFF
→
30°C
→
29°C
→
30°C
→
29°C
→
30°C
→
29°C
→
30°C
→
(test run)
→
ON/OFF
Wireless remote controller
1
When TEMPORARY button is pushed for
10 seconds or more, “Pi!” sound is heard
and the operation changes to test run. After
approx. 3 minutes, a cooling operation
starts forcedly.
Check cool air starts blowing. If the operation
does not start, check wiring again.
2
To stop a test operation, push TEMPORARY
button once again (Approx. 1 second).
Check wiring / piping of the indoor and outdoor
units in test run.
TEMPORARY button
■
When a test run is not performed
properly
•
When a test run is not performed properly, refer
to the error code and the part to be checked on
“Troubleshooting”.
•
When a test run is executed before installing
the external duct, a protection control may be
activated and lets the unit stop and the code
P12 may be displayed. (This is not due to a
malfunction but to the current control function
of the DC motor in this unit.) When a test run
executed before installing the external duct,
select “Low” for the fan speed level or cover the
air discharge.
•
In addition, stop the operation before replacing
the High-ef
fi
ciency
fi
lter or opening the service
panel. After the test run, reset the circuit
breaker of the indoor unit.
