Installation Manual
–
30
–
30-EN
11
APPLICABLE CONTROLS
REQUIREMENT
When you use this air conditioner for the
¿
rst time, it takes approx. 5 minutes until the
remote controller becomes available after
power-on. This is normal.
<When power is turned on for the
¿
rst
time after installation>
It
takes
approx. 5 minutes
until the remote
controller becomes available.
Power
on
“SETTING”
À
ashes
“SETTING”
goes out
Remote
controller is
available
Approx. 5 minutes
<When power is turned on for the second
(or later) time>
It
takes
approx. 1 minute
until the remote
controller becomes available.
Power
on
“SETTING”
À
ashes
“SETTING”
goes out
Remote
controller is
available
Approx. 1 minutes
Normal settings were made when the indoor
unit was shipped from factory.
Change the indoor unit settings as required.
Use the wired remote controller to change
the settings.
* The settings cannot be changed using
the wireless remote controller, sub remote
controller, or remote-controller less system
(for central remote controller only).
Therefore, install the wired remote
controller to change the settings.
•
For using the wired remote controller
RBC-AMS55E
*
, refer to the Owner’s Manual
attached to the wired remote controller.
■
Applicable controls setup
(settings at the site)
Remote controller model name:
RBC-ASCU1
Basic procedure
Be sure to stop the air conditioner before
making settings.
(Change the setup while the air conditioner is not
working.)
CAUTION
Set only the Code No. shown in the following
table: Do NOT set any other Code No.
If a Code No. not listed is set, it may not be
possible to operate the air conditioner or other
trouble with the product may result.
3,6
4,5
1
7
2,4,5
1
Push and hold menu button and [ ] setting
button simultaneously for 10 seconds or
more.
•
After a while, the display
fl
ashes as shown in
the
fi
gure. “ALL” is displayed as indoor unit
numbers during initial communication
immediately after the power has been turned
on.
Indoor unit No.
2
Each time [ ] [ ] setting button is pushed,
indoor unit numbers in the group control
change cyclically. Select the indoor unit to
change settings for.
•
The fan of the selected indoor unit runs.
The indoor unit can be con
fi
rmed for which
to change settings.
