Toshiba RAS-B10J2FVG-E, Installation Manual, Page: 15 / 384

EN
ES
FR
IT
DE
PT
PL
CZ
RU
CR
HU
TR
NL
GR
SV
FI
NO
DK
RO
BG
EE
LV
SK
SI
13
OTHERS OTHERS
Gas Leak Test
Remote Control A-B Selection
To separate using of remote control for each indoor unit in case of 2 air
conditioners are installed near.
Remote Control B Setup.
1. Push and hold [ ] button on the Remote Control by the tip of the
pencil. “00” will be shown on the display. (Picture 1 )
2. Press during pushing [ ]. “B” will show on the display and “00”
will disappear and the air conditioner will turn OFF. The Remote Control
B is memorized. (Picture
2 )
Note : 1. Repeat above step to reset Remote Control to be A.
2. Remote Control A has not “A” display.
3. Default setting of Remote Control from factory is A.
1 2
• Check the fl are nut
connections for the gas
leak with a gas leak
detector or soap water.
Check places for fl are nut connection
(Indoor unit)
Valve cover
Check places for the outdoor unit.
• When two indoor units are installed in the same room or adjacent two
rooms, if operating a unit, two units may receive the remote control
signal simultaneously and operate. In this case, the operation can
be preserved by setting either one indoor unit or remote control to B
setting (Both are set to A setting in factory shipment).
• The remote control signal is not received when the settings of indoor
unit and remote control are different.
• There is no relation between A setting/B setting and A room/B room
when connecting the piping and cables.
Test Operation
To switch the TEST RUN (COOL) mode, press [OPERATION] button for
10 seconds (The beeper will make a short beep).
A
Auto Restart Function Setting
The product was shipped with Auto Restart function in the OFF position.
Turn it ON as required.
This product is designed so that, after a power failure, it can restart
automatically in the same operating mode as before the power failure.
Information
How to turn ON the Auto Restart Function
How to turn OFF the Auto Restart Function
• Press and hold the [OPERATION] button on the indoor unit for 3 seconds
(3 beep sounds and OPERATION lamp blink 5 time/sec for 5 seconds).
• Press and hold the [OPERATION] button on the indoor unit for 3 seconds
(3 beep sounds but OPERATION lamp does not blink).
Setting of Remote Control
Selector Switch
Remote control selector switch
When two indoor units are installed in the separated rooms, it is not
necessary to change the selector switches.
Unit B setup.
Press and hold button for more than 20 seconds.
When A setup changed to B setup : 5 beeps will sound and operation
lamp blinks for 5 seconds.
When B setup changed to A setup : 5 beeps will sound.
NOTE
• In case of ON timer or OFF timer are set, AUTO RESTART OPERATION
does not activate.