Toshiba MMU-AP0152SH, Service Manual

Page: 102 / 119

102
Knob Knob Knob
Rear hinge Rear hinge Rear hinge
Screws (2 positions) Screws (2 positions) Screws (2 positions)
Projection Projection Projection
9. DETACHMENTS
MMU-AP0152SH, AP0182SH, AP0242SH
Ceiling panel: RBC-US21PGE
No.

Part name
Suction grille
Procedure
REQUIREMENT
Be sure to put on gloves when working;
otherwise an injury may be caused.
1. Detachment
1) Stop operation of the air conditioner, and
then turn off switch of the breaker.
2) Open the grilles by sliding knobs toward
suction side.
(Both 2 pieces at left and right sides)
3) Pull out the grille by pushing claws at rear
hinge (2 positions) with (–) screwdriver.
2. Attachment
1) Insert the rear hinge (2 positions) into
square holes of the panel.
(Insert it surely up to the end.)
NOTE)
After inserting the hinge, check the grille does
not fall out even if pulling the grilles.
2) Close the grilles and slide the hooks
(2 positions) toward discharge side to fix
them.
Remarks
Electric parts
cover
‚
1. Detachment
1) Perform work of procedure 1. of

.
2) Loosen fixing screws. (Ø4 × 8, 2 pcs)
3) Pull down the cover and shift it to the fan
motor side to remove it.
2. Attachment
1) Insert the cover along edge of the electric
parts box and match the projection inside
of the fixing screw with hole of the cover.
2) Tighten the fixing screws.
(Ø4 × 8, 2 pcs)