Toshiba MMU-AP0072WH, Installation Manual

Page: 26 / 36

SMMS 2-way Air Discharge Cassette Type Installation Manual
25
EN-49 EN-50
10
MAINTENANCE
CAUTION
• Before maintenance, be sure to turn off the circuit
breaker.
• Do not clean the filter with all the hooks of the
center panel disengaged and with only one or two
wires still attached to the center panel. Doing so
may cause the center panel to fall down, possibly
causing injury to any individuals below.
Cleaning of air filter
• If is displayed on the remote controller, maintain the
air filter.
• Clogging of the air filter reduce cooling/heating
performance.
Cleaning of panel and air filter
1. Turn off the air conditioner
• Set the circuit breaker to OFF.
2. Open the center panel
• Loosen the screws on the center panel holders
fixed to the frame covers by turning them about
three times. There is a frame cover on each long
side of the panel.
While removing the center panel, as the panel
moves, the panel pushes the center panel holders
and makes the holders slide.
• The direction in which the center panel opens is
fixed.
The side that moves when the edge of the center
panel is pushed upward is the end that opens; the
end that barely moves is the hooking side.
2-1. While pushing the edge at the opening side of
the center panel upward (1), pull the panel
toward the opening side (2).
2-2. When the panel is pulled toward the opening
side, the hooking side drops down by one step,
and the hooks at the opening side are
disengaged.
* Take hold of the center panel near the hooks at
both ends, and disengage the opening side hooks
one at a time.
If the center panel holders refuse to slide, loosen
the screws a little more using the screwdriver.
Frame cover
Screw
Center panel
holder
Screw
Center panel
holder
Center panel
Center panel holder Frame cover
Center panel holder
Slide
(1)
(2)
(1)
(2)
This side drops
down one step.
Center panel
2-3. Once you have checked that the hooking side
at both ends has dropped down by one step,
slowly rotate the panel downward (3), and open
it.
* The center panel opens until there is no more
slack in the wires at both ends.
3. Remove the air filter
• Take hold of the air filter knobs, and while pushing
the filter diagonally (1), pull it downward (2), and
remove it from the openings of the center panel.
4. Remove the dust using a vacuum cleaner or rinsing
it off in water
• When dust has accumulated on the filter, it can be
cleaned effectively using lukewarm or cold water
into which some neutral detergent has been
dissolved.
• After rinsing off the filter, allow it dry out in the
shade.
5. Mount the air filter
• Insert the air filter until it touches the back
surface. Take hold of the knobs, raise the air filter
until it touches the back surface, left go of the
knobs, and install.
6. Close the center panel
• Slowly rotate the center panel upward (1), and
close it.
• With the opening side of the center panel now
closed, while lifting the step of the hooking side
(2), slide the center panel toward the hooking side
(3), and secure it.
* Take hold of the center panel near the hooks at
both ends, and engage the hooks one at a
time.
(3)
Wire
Hooks
(1)
(2)
Tab
Knob
Air filter
Air filter
(1)
Hooks
Center panel
(2)
(3)
(2)
(3)
Step