Toshiba MCY-MAP0401HT2DZ, Owner'S Manual

Page: 15 / 24

EN
– 14 –
„
4-way cassette type
• The louver automatically closes when running is
stopped.
• In pre-heating mode, the louver points upward.
The swing indication appears on the remote
controller even in pre-heating mode, but the actual
swing starts only after pre-heating is complete.
▼
2-way and 3-way air discharge
The air discharge can be changed to the 2-way or 3-
way type to suit your room shape and style.
For details, contact the dealer where you purchased
the air conditioner.
„
2-way cassette type
„
1-way cassette type
(SH series)
• The louver automatically closes when running is
stopped.
• In pre-heating mode, the louver points upward.
The swing indication appears on the remote
controller even in pre-heating mode, but the actual
swing starts only after pre-heating is complete.
▼
When cooling
Point the louver horizontally.
▼
When heating
Point the louver downward.
▼
When cooling
Point the louver horizontally to send cool air across the
entire room.
▼
When heating
Point the louver downward to send heated air to the
floor.
▼
When cooling
Point the louver horizontally to send cool air across the
entire room.
▼
When heating
Point the louver downward to send heated air to the
floor.
NOTE
To improve the cooling / heating performance, change
the louver angle for each operation.
◆
To set the air discharge direction
to forward using a front air
discharge unit (sold separately)
CAUTION
When applying a front air discharge unit to the
indoor unit, the 2-way air discharge function
(f downward) is not available.
Such use may lower the air temperature and cause
water leakage.
For details on the installation, read the installation
manual that comes with a front air discharge unit (sold
separately).
When using a front air discharge unit (sold
separately) for an indoor unit of the 1-way cassette
type, follow the procedure below to change
discharge direction:
Vertical adjustment
NOTE
1. When sending air downward, bend the louvers
evenly as shown in the following figure.
If the air flow is blocked, water droplets may fall
down from the air discharge.
2. Set the angle of the louver to 40° or lower.
If the angle is over 40°, droplets may fall down.
Horizontal adjustment
NOTE
When adjusting air direction horizontally, arrange the
angles of the vertical grilles gradually as shown in the
following figure.
If the air flow is blocked, water droplets may fall down
from the air discharge.
▼
When cooling
Move the louver manually and point it horizontally to
send cool air across the entire room.
▼
When heating
Move the louver manually and point it downward to
send heated air to the floor.
Louver
Use the vertical grille behind the louver to even the
room temperature.
Louver
NO GOOD GOOD
40° or lower
Vertical grille
Vertical grilles
NO GOOD
GOOD
27-EN 28-EN