Toshiba MCY-MAP0401HT2DZ, Owner'S Manual

Page: 16 / 24

– 15 –
„
Ceiling type
Vertical adjustment
• The louver automatically points upward when
running is stopped.
• In pre-heating mode, the louver points upward.
The swing indication appears on the remote
controller even in pre-heating mode, but the actual
swing starts only after pre-heating is complete.
Horizontal adjustment
„
1-way cassette (YH series),
and floor standing types
◆
Setting the direction and swinging
1
Push the button during running.
If 1 remote controller controls 2 or more indoor
units, you can configure the direction setting for
each unit individually.
Push the button again while the louver
is swinging.
2
You can stop the louver in your preferred
position.
◆
Unit select
• When two or more indoor units are controlled with
one remote controller, the louver direction can be set
for each indoor unit by selecting them individually.
• To set louver direction individually, push the
button (left side of the button) to display an indoor
unit number in the control group. Then set the louver
direction of the displayed indoor unit.
• When no indoor unit number is displayed, all indoor
units in the control group can be controlled
simultaneously.
• Each time you push the (left side of the
button), the indication changes as follows:
▼
When cooling
Point the louver horizontally to send cool air across the
entire room.
▼
When heating
Point the louver downward to send heated air to the
floor.
When adjusting louver direction horizontally, point the
vertical grille inside the horizontal louver in your
preferred direction.
SWING/FIX
SWING/FIX
1,2
SET
TIME
TIMER SET
TEST
FILTER LL
RESET
TEMP.
CL
FAN
SAVE A A
SWING/FIX
VENT
MODE
ON / OFF
UNIT LOUVER
Unit select
UNIT LOUVER
UNIT LOUVER
Unit No.
1-4
No
display
Unit No.
1-1
Unit No.
1-2
Unit No.
1-3
„
1-way cassette type
(YH series)
Vertical adjustment
Horizontal adjustment
NOTE
To improve the cooling / heating performance, change
the louver angle for each running mode.
„
Floor standing type
Vertical adjustment
Horizontal adjustment
▼
When cooling
Point the louver horizontally to send cool air across the
entire room.
▼
When heating
Point the louver downward to send heated air to the
floor.
To send air horizontally, point the vertical grilles inside
the louver in your preferred direction.
▼
When cooling
Move the louver manually and point it horizontally to
send cool air across the entire room.
▼
When heating
Move the louver manually and point it downward to
send heated air to the floor.
▼
Sending air in different directions
Lift up the vertical louvers slightly and point them in
your preferred directions.
1
2
In this case, do not use the
auto swing function.
29-EN 30-EN