13
TROUBLESHOOTING HINTS
1. The bell does not ring.
When the PAGE SW of the
base is pressed, does the
ringer on the handset ring?
When the TEL SG is joined
with the base to make bell
signal, is there pulse wave on
Pin 4 of IC2?
Then, is there pulse wave
on Pin 24 of IC3?
By using voltage chart,
check IC3.
Check the surrounding
circuit where the voltage is
incorrect.
By using voltage chart, check
IC2.
Check TEL network primary
circuit.
Check IC3, C85, R45 and
R44.
IC3 is defective.
See 2. The bell does not ring
& page does not ring.
IC2 is defective.
OK
NG
OK
OK
NG
OK
NG
OK
NG
NG
Summary of Contents for FT-7007LBR
