Toshiba D-R160SB, Owner'S Manual

Page: 19 / 67

Introduction
Recording
Playback
Editing
Introduction
Connections
Basic Setup
Function Setup
Others
19 EN
Installing batteries in the remote
control About the remote control
Preparation of the remote control
■ Install two R6 (AA) batteries (supplied) into the
remote control, carefully match with the
polarity indicated inside the battery
compartment.
1
Open the cover.
2
Insert batteries.
Make sure to match the + and - on the
batteries to the marks inside the battery
compartment.
3
Close the cover.
■ Keep in mind the following when using the
remote control:
●
Make sure there is no obstacle between the remote
control and the remote control sensor on the unit.
● Use within the operating range and angle as
shown.
● Remote control operation may become unreliable if
the remote control sensor of the unit is being
exposed by the strong sunlight or fluorescent light.
●
Remote controls for different devices can interfere
with each other. Be careful when using remote
controls for other equipment located close to the
unit.
● Replace the batteries when the operating range of
the remote control reduces.
●
The maximum operable range as follows:
-
Line of sight
:
approximately 7 m
-
Either side of the centre
:
approximately 7 m within 30 degrees
REC MODE REC
PROGRAM
ON/STANDBY
I / y
Notes:
• Incorrect use of batteries can result in hazards such as
leakage and bursting.
• Do not mix new and old batteries together.
• Do not use different kinds of batteries together.
• Make sure that the + and - ends of each battery match the
indications inside the battery compartment.
• Remove batteries if the remote control will not be used for
an extended period of time.
• When disposing used batteries, please comply with
governmental regulations or the public instructions for
environmental protection that apply in your country or
area.
• Do not recharge, short-circuit, heat, burn or disassemble
batteries.
02̲Introduction̲BD.indd 19 02̲Introduction̲BD.indd 19 2006/02/24 18:01:16 2006/02/24 18:01:16