12
Introduction
Preparation of the remote control
Operating with the remote control
Point the remote control at the remote sensor and
press the buttons.
Distance :
About 7 m from the front of the remote
sensor
Angle
:
About 30
°
in each direction of the front of
the remote sensor
* Do not expose the remote sensor of the recorder to a
strong light source such as direct sunlight or other
illumination. If you do so, you may not be able to
operate the recorder via the remote control.
Notes
• Do not drop or give the remote control a shock.
• Do not leave the remote control near an extremely hot or
humid place.
• Do not spill water or put anything wet on the remote control.
• Do not disassemble the remote control.
1
Open the cover.
2
Insert batteries (R6 type).
Make sure to match the + and – on the
batteries to the marks inside the battery
compartment.
3
Close the cover.
Notes on batteries
Improper use of batteries may cause battery leakage and
corrosion. To operate the remote control correctly, follow the
instructions below.
• Do not insert batteries into the remote control in the wrong
direction.
• Do not charge, heat, open, or short-circuit the batteries. Do
not throw batteries into a fire.
• Do not leave dead or exhausted batteries in the remote
control.
• Do not use different types of batteries together, or mix old
and new batteries.
• If you do not use the remote control for a long period of
time, remove the batteries to avoid possible damage from
battery corrosion.
• If the remote control does not function correctly or if the
operating range is reduced, replace all batteries with new
ones.
• If battery leakage occurs, wipe the battery liquid from the
battery compartment, then insert new batteries.
Within about 7 m
30
°
30
°
1
2
3
4
5
6
+10
7
8
9
0
CLEAR
DVD
TV
OPEN/CLOSE
TIME SLIP
TV VOL
CH
T.SEARCH
PROGRESSIVE
INPUT SEL.
TOP MENU
MENU
SKIP FWD
SKIP REV
ON/STANDBY
02_D-R150SB(E)_inst02-12
05.7.13, 0:23 AM
12
