Installation
Step 1: Obtain License for the Console
2
Strata CIX IP Attendant Console Installation 01/09
Step 1: Obtain License for the Console
Be sure to contact Toshiba Telecommunication Systems Division’s (TSD) Customer Service
department to obtain an order number. Use the FYI license key generator to obtain a license for
a single or multiple consoles.
Step 2: Program CIX for the Console
Certain programming assignments are required in the Strata CIX for the CIX Attendant Console;
others are preferred or recommended assignments for proper operation. You can use eManager or
CIX telephone button programming.
Step 2A: Assign Class of Service (COS) on CIX
Select
System > Class of Service
(Program 103), then use the following Feature Buttons
(FBs) to make the following assignments:
p
FB00 – Specifies the COS, Toshiba recommends using “COS=10” for the Attendant
Console (recommended).
p
FB01 – Enter
2
to disable Auto Busy Redial (required).
p
FB06 – Enter
2
to disable this feature so that calling parties with Do Not Disturb (DND)
Override privileges cannot override the Console’s DND status (required).
p
FB09 – Enter
1
to enable Executive Override privileges for the console (preferred).
p
FB10 – Enter
2
to disable Executive Override for others calling the console (required).
p
FB12 – Enter
1
to enable Group Pickup (preferred).
p
FB13 – Enter
1
to enable Directed Station Pickup (preferred).
p
FB14 – Enter
1
to enable Directed Group Call Pickup (preferred).
p
FB15 – Enter
1
to enable Directed DN Call Pickup (preferred).
p
FB16 – Enter
1
to enable External Call Pickup (preferred).
p
FB17 – Enter
1
to enable Directed CO Call Pickup (preferred).
p
FB20 – Enter
1
to enable the console to switch from ringing to handsfree answerback
(preferred).
p
FB21 – Enter
1
to enable Privacy Override (preferred).
p
FB23 – Enter
1
to enable Emergency Paging (preferred).
p
FB24 – Enter
1
to enable the ability to Join calls (required).
p
FB25 – Enter
1
to enable Through Dialing (required).
p
FB26 – Enter
1
to enable Tandem (Trunk-to-trunk) Connections (preferred).
p
FB27 – Enter
1
to enable the ability to change Day/Night mode (required).
p
FB30 – Enter
1
to enable the ability to dial individual trunk access codes to access
specified lines (preferred).
p
FB31 – Enter
1
to enable access to trunk groups by trunk access codes (required).
p
FB34 – Enter
1
to enable use of a Short Flash signal over CO lines (required).
p
FB35 – Enter
1
to enable use of a Long Flash signal over CO lines (required).
p
FB36 – Enter
1
to enable the ability to receive Hook Flash over CO lines (required).
p
FB38 – Enter
2
to disable the ability of other stations to call the console using Off-hook
Call Announce (required).
