13
TROUBLESHOOTING
If you have any problems during using this product, please check the following point first.
If a problem cannot be solved by taking actions described below, unplug the battery charger and
contact the dealer or an authorised TOSHIBA TEC service representative for assistance
Symptom
Cause and resolution
A battery pack is loaded in the
battery charger, but the CHARGE
lamp does not light up in red
•
The power cord or AC adapter is not connected properly.
⇒
Firmly connect the power cord or AC adapter.
•
The terminals of the battery charger or the battery
electrodes are stained.
⇒
Wipe clean those portions with a soft dry cloth.
•
You are attempting to charge a battery pack with the over
discharge protection activated (The CHARGE lamp may not
light up immediately after loading a battery.)
⇒
Leave the battery charger and the battery pack alone
for a few minutes. If the CHARGE lamp does not light after
all, stop using the battery pack, as the battery pack may
be faulty.
•
The partition is not fitted.
⇒
Fit the partition in the correct orientation.
The CHARGE lamp blinks in red.
•
A battery pack failure is detected.
⇒
It could be the end of battery life. Replace the battery
pack with a new one.
Charging time overruns the
approximate specified time.
•
Charging time varies depending on the condition of the
battery pack, ambient temperature, etc.
⇒
If the battery charger continues charging even after the
specified time has passed, stop charging and replace
the battery pack with a new one.
Battery does not last long time
though the battery is fully charged.
•
It could be the end of battery life.
⇒
Replace the battery pack with a new one.
The battery pack cannot be inserted
into the slot.
•
The partition is not set completely.
⇒
Fit the partition completely.
