English
- 12 -
English
Initial Installation
Before switching on the TV, put your decoder and media recorder to
Standby
if they are connected and
ensure the aerial
and/or Satellite dish
is connected to your TV. To set up the TV, use the buttons on the
remote control as detailed on
page 6
.
IMPORTANT: Ensure that the aerial
and/or Satellite
dish
is connected and a Common Interface module
is not inserted before switching on the TV for the first
time installation.
1.
Connect the mains plug and switch the TV to
on
using
the
/ I
button. If the TV does not switch on,
press any numbered or button on the remote
control, then the language selection menu will
be displayed. This screen will appear the first
time that the TV is switched on and each time
the TV is reset.
2.
By pressing
Up
or
Down
button, highlight the
language you want to set and press
OK
button.
The following message will be displayed next:
3.
By pressing
Left
or
Right
button, select the
country
you want to set and press
Down
button
to highlight the
Search Type
option. Use
Left
or
Right
to set the desired search type. Available
search types are digital only, analog TV only
and full.
4.
When set,
Down
button to select Teletext
Language. Use
Left
or
Right
button to select
desired Teletext Language.
5.
Press
OK
button on the remote control to continue
and the following message will be displayed on
the screen:
6.
Select
Yes
button by using
Left
or
Right
button
and press
OK
button to continue. Afterwards, the
following OSD will be displayed on the screen:
7.
If you select
Cable
option, the following screen
will be displayed:
Note:
Although this cable feature can be selected,
it is not fully supported in the UK. If cable signals
are input to this TV from a Cable Network Provider
some may be displayed.
8.
You can select frequency ranges from this
screen. For highlighting lines you see, use
Up
or
Down
button. You can enter the frequency range
manually by using the numeric buttons on the
remote control. Set Start and Stop Frequency as
desired by using numeric buttons on the remote
control. After this operation, you can set Search
Step as 8000 kHz or 1000 kHz. If you select
1000 kHz, the TV will perform search process
in a detailed way. Searching duration will thus
increase accordingly. When finished, press
OK
button to start automatic search.
9.
If you select
Aerial
option from the Search Type
screen, the television will search for broadcasts.
