English
- 11 -
English
Controlling the TV
A wide variety of external equipment can be connected via the sockets located on the side and back of the
TV.
Whilst all the necessary adjustments and controls for the TV are made using the remote control, the
buttons on the Back
of the TV may be used for some functions.
Switching on
If the standby LED is unlit, check that the mains
plug is connected to the power and press the
/ I
button on the back side of the television to switch the
television on.
To put the television into Standby, press button on
the remote control or on the TV. To view the television,
press button again. The picture may take a few
seconds to appear.
Note
: The active Standby LED colour will turn to red in a few
moments when the TV is switched into Standby.
For energy saving:
Turning the TV off at its mains supply, or un-plugging
it, will cut energy use to nearly zero for all TV’s. This
is recommended when the TV is not being used for a
long time, e.g. when on holiday.
Reducing the brightness of the screen will reduce
energy use. Energy efficiency cuts energy consumption
and thus saves money.
NOTE
: Putting the TV into standby mode, will reduce energy
consumption, but will still draw some power.
Using the Remote Control
Press the
MENU
button on the remote control to see
the menus.
The main menu appears as a group of icons each
for a menu option. Press the Left or Right button to
select a topic.
In sub menu screen
mode the menu appears as a
list. Press the Up or Down button to select a topic.
To use the options press the Up and Down
buttons
on the remote control to move up and down through
them and
OK
, Left or Right
buttons to select the
required choice. Follow the on screen instructions.
The functions of each menu are described in detail
throughout the manual.
Using the Controls on the TV
Using the control buttons on the Back of the TV:
• To alter the volume press
+
or
-
.
• To alter the programme position press
P
on
the Back of the TV.
• Press
+
-
buttons at the same to view main
menu and use
P
to navigate and
+
-
to
change value.
To select an external input, press
until the
appropriate input source is selected.
Please always refer to the owner’s manual of the
equipment to be connected for full details..
