1 - 15
Oct. 1995 © TOSHIBA CORP.
1550 ADJUSTMENT
1.3.A Installing the Carriage Drive Wire
(1)
Set the wire so that its spherical terminal is
placed in the hole of the wire take-up pulley.
(3)
Wrap the wires on the front and rear sides, as shown and fasten them with screws.
(2)
Using the wire holder jig, wrap the wire on the
take-up pulley, 3-1/4 turns of the fixture-side
end and 5-1/4 turns of the other end.
Wire take-
up pulley
Spherical terminal
Wire take-up pulley
Wire holder jig
[Front side]
closely fit
[Rear side]
Hook (feed side)
Hook (feed side)
Front side wire fixture
(Marking “F”)
Shaft
closely fit
closely fit
closely fit
5
turns
1
4
3
turns
1
4
5
turns
1
4
3
turns
1
4
Spherical terminal
Rear side
wire
fixture
(Marking
“R”)
