24
Fault Codes
Display Cause
What to do
E02
Engine overheating
Motor can be used again after a short wait (about
10 minutes) Contact Torqeedo Service.
E03
Motor tilted during operation Motor can be used again after tilting it down and
pressing on/off.
E04
Motor put into operation
while tilted
Motor can be restarted from the stop position after
being tilted down.
E05
Motor/propeller blocked
Loosen blockage and turn propeller one revolution
by hand.
E06
Voltage in motor too low
Low battery charging status. Motor can be used
again slowly from the stop position.
E07
Motor Overcurrent
Continue at low output. Contact Torqeedo
Service.
E08
Circuit board overheating
Motor can be used again after a short wait (about
10 minutes). Contact Torqeedo Service.
E21
Remote Throttle calibration
defective
Re-Calibrate Throttle by:
1. Press the middle button for 10 seconds. The
display will show “cal up”.
2. Press remote throttle control to full gas then
press the middle button.
3. The display shows “cal stp”. Return remote
throttle control to central position then press the
middle button.
4. The display shows “cal dn”. Press the remote
throttle control to full reverse position then press
middle button.
E22
Magnetic sensor defective
Re-calibrate (refer to E21)
E23
Value range false
Re-calibrate (refer to E21)
E30
Motor communication error
1. Check the motor cable’s plug-in connection.
2. Check the motor cable for damage.
3. Check the fuse on the underside of the battery.
If applicable replace the fuse. If the fuse is
replaced, the information display will not show
correct data until the battery is fully charged again.
E32
Remote throttle control
communication error
Check the remote throttle control cable’s plug-in
connection. Check the cable.
E33
General communication
error
Check the plug-in connections and cables. Switch
the motor off and on again.
E41,42 Incorrect charging voltage
Check whether the power supply unit used has
an output voltage between 10 V and 20V. If
necessary contact Torqeedo Service.
E43
Battery empty
Charge battery. Motor can be used again slowly
from the stop position if necessary.
E45
Battery overcurrent
Switch motor off and on again. The information
display will not show correct data after this error
occurred. The battery needs to be fully charged to
reset the information system.
Troubleshooting and Care Instructions
