Specifications
Note:
Specifications and design are subject to change
without notice.
Overall Width
160 cm (63 inches)
Overall Length
Without bed: 326 cm (128.25 inches)
With full bed: 331 cm (130.38 inches)
With 2/3 bed in rear-mounting
location: 346 cm (136.38 inches)
Base Weight (Dry)
838 kg (1,848 lb)
Rated Capacity
(includes 91 kg (200
lb) operator, 91 kg
(200 lb) passenger and
loaded attachment)
1,362 kg (3,002 lb)
Maximum Gross
Vehicle Weight
2,359 kg (5,200 lb)
Tow Capacity
Tongue weight 272 kg (600 lb)
Maximum trailer weight 1,587 kg
(3,500 lb)
Ground Clearance
18 cm (7 inches) with no load
Wheel Base
118 cm (70 inches)
Wheel Tread (center
line to center line)
Front: 117 cm (46 inches)
Rear: 121 cm (47.7 inches)
Height
190.5 cm (75 inches) to top of ROPS
Attachments/Accessories
A selection of Toro approved attachments and accessories is
available for use with the machine to enhance and expand
its capabilities. Contact your Authorized Service Dealer or
Distributor or go to www.Toro.com for a list of all approved
attachments and accessories.
Operation
Note:
Determine the left and right sides of the machine
from the normal operating position.
CAUTION
A raised bed full of material without the proper
safety support rod may lower unexpectedly.
Working under an unsupported raised bed may
cause injury to you or others.
•
Before servicing or making adjustments to the
machine, shut off the engine, set the parking
brake, and remove the key from the ignition
switch.
•
Remove any load material from the bed or other
attachment and insert the safety support on
a fully extended cylinder rod before working
under a raised bed.
Operating the Cargo Box
Note:
If possible, center loads in the cargo box.
Note:
Remove all cargo from the box before lifting the box
up to service the machine.
Raising the Cargo Box
WARNING
Driving the machine with the cargo box raised may
cause the machine to tip or roll easier. The box
structure may become damaged if you operate the
machine with the box raised.
•
Operate the machine only when the cargo box
is down.
•
After emptying the cargo box, lower it.
CAUTION
If a load is concentrated near the back of the cargo
box when you release the latches, the box may
unexpectedly tip open, injuring you or bystanders.
•
Center loads in the cargo box if possible.
•
Hold the cargo box down and ensure that no
one is leaning over the box or standing behind it
when releasing the latches.
•
Remove all cargo from the box before lifting the
box up to service the machine.
Move the lever rearward to raise the cargo box (
).
19
Summary of Contents for Workman HD 07369
Page 55: ...Notes 55...