Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Description
Qty.
Use
No parts required
–
Prepare the machine.
Side upright frame bracket
2
Front upright frame bracket
2
Pipe bracket
1
Front support bracket (with 2 holes on each
side)
1
Cross-support bracket
1
Fire-extinguisher mount
1
Fire-extinguisher support
1
Shovel mount
3
Front support bracket (with 1 hole on each
side)
1
Hex-head screw (1/4 x 3/4 inch)
8
Carriage bolt (5/16 x 3/4 inch)
34
Flange nut (5/16 inch)
34
Cup-cutter bracket
1
Install the bed rack kit.
Preparing the Machine
Park the machine on a level surface, set the parking brake,
shut off the engine, and remove the key.
Installing the Bed Rack Kit
If you want to install the Bed Rack Kit on both sides of the
cargo bed, you will need the following
additional parts
:
•
1 side upright frame bracket
•
1 pipe bracket
•
1 cross-support bracket
•
1 fire-extinguisher mount
•
1 fire-extinguisher support
•
3 shovel mounts
•
4 hex-head screws (1/4 x 3/4 inch)
•
26 carriage bolts (5/16 x 3/4 inch)
•
26 flange nuts (5/16 inch)
•
1 cup-cutter bracket
Note:
The Bed Rack Kit can be installed on either side of
the cargo bed.
1.
Loosely install the 2 side upright frame brackets to the
outside of the cargo bed with 4 hex-head screws (1/4 x
3/4 inch) as shown in
.
Figure 1
1.
Side upright frame bracket
2.
Hex-head screw (1/4 x 3/4
inch)
2
Summary of Contents for Workman GTX Series
Page 7: ...Notes 7...
Page 8: ......
