Toro Workman 07235, Operator'S Manual

Page: 52 / 60

Checking the Brake-Fluid
Level
Service Interval: Before each use or daily—Check
the brake-fluid level. Check the
brake-fluid level before you first start
the engine.
Brake-fluid type: DOT 3
1. Park the machine on a level surface.
2. Engage the parking brake.
3. Shut off the engine and remove the key.
4. Raise the hood to access to the master brake
cylinder and reservoir (
Figure 67 ).
g033037
Figure 67
1. Filler neck (reservoir) 3. DOT 3 brake fluid
2. Reservoir cap
5. Look at the outline of the fluid level at the side of
the reservoir (
Figure 68 ).
Note:
The level should be above the Minimum
line.
g002136
Figure 68
1. Brake-fluid reservoir 2. Minimum line
6. If the fluid level is low, preform the following:
A. Clean the area around the reservoir cap
and remove the cap (
Figure 67 ).
B. Add DOT 3 brake fluid to the reservoir until
the fluid level is above the Minimum line
(
Figure 68 ).
Note:
Do not overfill the reservoir with
brake fluid.
C. Install the reservoir cap ( Figure 67 ).
7. Close the hood.
Changing the Brake Fluid
Service Interval: Every 1,000 hours
Contact your authorized Toro distributor.
52