Adjusting the High/Low Idle
1.
Lift the cargo bed and secure it open with the
prop rod.
2.
With the machine off, fully depress the
accelerator pedal and measure the gap between
the leading edge of the governor bellcrank and
the bracket tab. This gap should be between 0.8
to 2.0 mm (.03 to .08 inches).
3.
At the throttle cable, loosen the forward jam nut
and tighten the rear jam nut to increase the low
idle (
g228465
Figure 38
Bellcrank shown without accelerator pedal depressed
1.
Throttle cable
4.
Bracket tab
2.
Jam nuts
5.
Leading edge
3.
Bellcrank
4.
Test the high idle with a tachometer:
A.
Turn the engine on.
B.
Ensure that the shift lever is in the neutral
position.
C.
Fully depress the accelerator pedal
and measure the engine speed with a
tachometer; the engine speed should be
between 3550 to 3650 rpm. If it is not, shut
off the engine and adjust the cable jam nuts.
Important:
Do not lower the high idle.
Test with a tachometer to ensure that the
high idle is between 3550 to 3650 rpm.
5.
Push on the prop rod and lower the cargo bed.
Fuel System
Maintenance
Inspecting Fuel Lines and
Connections
Service Interval:
Every 400 hours/Yearly (whichever
comes first)
Inspect the fuel lines, fittings, and clamps for signs of
leaking, deterioration, damage, or loose connections.
Note:
Repair any damaged or leaking fuel system
component before using the machine.
Replacing the Fuel Filter
Service Interval:
Every 800 hours/Yearly (whichever
comes first)
1.
Raise the bed and support it with the prop rod;
refer to
Raising the Cargo Bed (page 18)
.
2.
Rotate the key switch to the O
FF
position and
remove the key from the key switch.
3.
Disconnect the battery; refer to
the Battery (page 41)
.
4.
Place a clean container under the fuel filter.
5.
Remove the clamps securing the fuel filter to the
fuel lines (
).
g002108
Figure 39
1.
Fuel filter
6.
Remove the old fuel filter from the fuel lines.
Note:
Drain the old filter and discard it at a
certified recycling center.
7.
Install the replacement filter to the fuel lines so
that the arrow points
toward
the carburetor.
8.
Secure the filter to the lines with the clamps the
you removed in step
.
9.
Connect the battery, and lower the cargo bed;
refer to
Connecting the Battery (page 42)
and
Lowering the Cargo Bed (page 19)
.
36
