Belt Maintenance
Inspecting/Replacing the Drive
Belt
Service Interval:
Every 25 hours—Inspect the drive belt for
wear or damage.
Every 200 hours—Replace the drive belt.
Replace the belt if you find any signs of wear, cracks, or
damage or after 200 operating hours, whichever comes first.
To replace the drive belt, complete the following procedure:
Note:
To complete this procedure, you need a sturdy
metal hook to disconnect the idler-pulley spring, such as the
Spring-Removal Tool (Toro Part No. 92-5771) available for
order from your Authorized Service Dealer.
1.
Lower the loader arms, shut off the engine, and remove
the key.
2.
Open the hood.
3.
Connect the hook on the spring-removal tool to the
hook on the idler-pulley spring, and disconnect the
spring from the stud as illustrated in
Figure 51
1.
Spring-removal tool
4.
Idler pulley
2.
Drive belt
5.
Engine (see-through for
illustrative purposes)
3.
Idler-pulley spring (spring
cover not shown)
4.
Remove the idler-pulley spring from the idler-pulley
assembly (
38
Summary of Contents for TX 427 22342HD
Page 49: ...Schematics g013124 Electrical Schematic Rev B 49...
Page 50: ...Hydraulic Schematic Rev A 50...
Page 51: ...Notes...
