Closing the Rear-Access
Cover
1.
Move the rear-access cover in place over the back of
the traction unit making sure that the tabs line up in
the slots.
2.
Push the access cover forward, lining up the hand-knob
screws with the threaded holes in the machine.
3.
Screw the hand knobs tight to secure the rear-access
cover in place.
Removing the Side Screens
1.
Open the hood.
2.
Slide the side screens (
) up and out of the
slots in the front screen and frame.
Figure 30
1.
Side screen
Installing the Side Screens
Slide the side screens into place in the slots in the front screen
and frame.
Removing the Front Screen
CAUTION
If the engine has been running, the heat shield will
be very hot and could burn you.
Allow the traction unit to cool completely before
touching the heat shield.
1.
Open the hood and remove both side screens.
2.
Loosen the bolts securing the weights (
).
g013122
5
Figure 31
1.
Front weight
4.
Carriage bolts
2.
Bolts
5.
Rear weight
3.
Sloped plate
3.
Remove the carriage bolts and nuts securing the sloped
plate (
).
4.
Lift the sloped plate up and off the traction unit.
5.
Remove the 4 bolts securing the front screen to the
traction-unit frame (
).
Figure 32
1.
Front screen
2.
Bolts (left side bolt not
shown)
6.
Remove the shoulder bolts and nuts securing the oil
cooler to the top of the front screen (
).
27
Summary of Contents for TX 427 22342HD
Page 49: ...Schematics g013124 Electrical Schematic Rev B 49...
Page 50: ...Hydraulic Schematic Rev A 50...
Page 51: ...Notes...
