WARNING
Loading a machine onto a trailer or truck increases
the possibility of tip-over and could cause serious
injury or death.
•
Use extreme caution when operating a machine
on a ramp.
•
Use only a full-width ramp; do not use individual
ramps for each side of the machine.
•
Do not exceed a 17-degree angle between the
ramp and the ground or between the ramp and
the trailer or truck.
•
Ensure that the length of ramp is at least 4 times
as long as the height of the trailer or truck bed to
the ground. This ensures that ramp angle does
not exceed 17 degrees on flat ground.
•
Load and unload the machine with the heavy
end up the ramp.
•
Avoid sudden acceleration or deceleration while
driving the machine on a ramp as this could
cause a loss of control or a tip-over situation.
g027996
5
1
2
6
Figure 26
1.
Full-width ramp in stowed
position
4.
Ramp is at least 4 times
as long as the height of
the trailer or truck bed to
the ground
2.
Side view of full-width
ramp in loading position
5.
H= height of the trailer or
truck bed to the ground
3.
Not greater than
17 degrees
6.
Trailer
24
Summary of Contents for TX 427 22342HD
Page 49: ...Schematics g013124 Electrical Schematic Rev B 49...
Page 50: ...Hydraulic Schematic Rev A 50...
Page 51: ...Notes...
