Toro TM5490, Operator'S Manual

Page: 63 / 94

1.63 1.63
Daily And Before Use
Check hydraulic oil level: Check the hydraulic oil
level in the sight glass with all cutterheads lowered
to the ground. The sight glass is located at the front
of the hydraulic reservoir beneath the pump cover.
If the level is below the top line, top up with the
correct grade of hydraulic oil as necessary, refer to
SPECIFICATIONS .
IMPORTANT: PREVENT DAMAGE - If there
is noticeable hydraulic oil loss, the leakage
source must be found and sealed before using
the mower. NEVER operate the mower when
the hydraulic oil level is below the bottom line
on the sight glass. NEVER operate the mower
with contaminated hydraulic oil.
Check hydraulic hose lines: Inspect hydraulic
hose lines for signs of wear or damage.
Inspect the mower for signs of oil leakage and
tighten fittings or replace seals as required.
WARNING: PREVENT ACCIDENTS - Always
replace worn or damaged hydraulic hose lines
immediately. DO NOT operate the mower with
defective hydraulic hose lines.
Check safety devices:
WARNING: PREVENT ACCIDENTS - Ensure
that all safety guards, shields and protective
devices are securely in place and in good work-
ing order.
Check fasteners: Check that all nuts, bolts and
pins are secured correctly in place and in good
condition.
Check tyres: Examine the condition of the tyres
and check that inflation pressures are correctly set,
refer to SPECIFICATIONS .
WARNING: PREVENT ACCIDENTS -
Ensure that damaged tyres are replaced. Ensure
that tyre tread depths comply with road traffic
regulations.
Check cutterheads: Examine the condition of the
cutting cylinders and the bottom blades and adjust
as necessary, refer to CYLINDER TO BOTTOM
BLADE ADJUSTMENT .
MAINTENANCE