g036752
Figure 90
1.
Cotter pin
3.
Brake linkage shaft
2.
Parking brake
7.
Check both spring lengths as shown in
. If an adjustment is necessary, turn the
top nut clockwise to shorten the spring and
counterclockwise to lengthen it.
g036100
Figure 91
1.
Top nut
3.
44 mm (1-3/4 inches)
2.
Spring
8.
Push the parking brake lever all the way forward
and down.
9.
Rotate the brake-linkage shaft until the end
aligns with the hole in the lever.
•
Shorten the linkage by turning it clockwise.
•
Lengthen the linkage by turning it
counterclockwise.
10.
Insert the brake-linkage shaft into the
parking-brake hole and secure with the cotter
pin. Repeat step
and adjust if necessary.
11.
When adjustment is complete, remove the jack
stands or equivalent support and lower the
machine.
12.
Place the machine into the O
PERATING
position.
Refer to
Using the Drive-Wheel Release Valves
(page 35)
.
65
